G2 1/2 Gallon kit up to 95 sq ft

Surface Preparation
GatorGlide G2 is a silicone-epoxy coating having unique release properties while adhering to a broad range of substrates including wood, concrete, fiberglass, metals, and most plastics including epoxies, polyurethanes, and alkyds. GatorGlide G2 has excellent abrasion and slip properties.

 Mixing Instructions:

GatorGlide G2 is a 2 component product. GatorGlide G2 is packaged in 1 Gallon and 5 Gallon kit which contains the proper ratio of ingredients. The entire contents of each container should be mixed together. For quantities less than the pre-packaged kit, mix as follows: To 11 parts of the A component, mix in 2 parts of the B component. Mix the A and the B until completely blended. NO INDUCTION PERIOD NECESSARY...Spray or Roll immediately.

 Roll or spray GatorGlide G2 for a 3 to 4 mil dry or 6 to 8 wet mil
coating. Roll or spray in two or three increments to avoid sagging if
a heavier deposit is required. Apply the last coat as a thin 2 to 3 mil dry
coating to obtain the best smoothness and abrasion resistance. If poor wetting
occurs while applying GatorGlide coatings, then lightly roughen the dry
GatorGlide surface with 400 grit sandpaper prior to top-coating. Make sure the
surface temperature is above 40°F and the relative humidity is below 90% before
coating. Allow at least 48 hours and ideally one week of curing before putting
into service. Post heating at elevated temperatures will speed up curing and
improve the abrasion resistance. Do not use harsh chemicals for cleaning
GatorGlide surfaces, a simple hand wipe or a light scrape is adequate for
removing marine growth. If the GatorGlide surface has become damaged or has
excessive wear, then an occasional touch up may be required. This can be
achieved by simply rolling or spraying 1 to 3 mils of the GatorGlide G2 over
the existing GatorGlide surface and allowing it to cure for at least 24 hours
prior to putting it back in service.


G2 1/2 Gallon kit up to 95 sq ft
Click To Enlarge
  • Item #: G2 1/2
  * Marked fields are required.
Price $118.00